Loba Amberizer Water-Based Wood Floor Finish Additive – 3 oz.

Loba Amberizer is suitable for all LOBA water-based finishes. For all dark wood species as well as dark-colored wood surfaces. For light wood species we recommend you consult us.

Processing Instructions

• Sand and prepare floors according to NWFA guidelines.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Shake material well before use.
• Do not thin. Do not add water.
• Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
• Apply evenly at the recommended coverage rate. Avoid streaks, puddles, and lap marks.

Drying time

• Amberizer does not alter the dry time of the desired finish.

Mixing ratio

Added amount 2%. One bottle to one gallon.

Recommended Procedure for Wood Floors

• Add Amberizer only right before the application by shaking or stirring thoroughly. When using 2-component-systems
• (2K Duo, 2K Supra A.T.) add Amberizer only AFTER adding hardener to the mass!
• 1K finish mixed with LOBA Amberizer must be applied within 24 hours, 2K finishes within the indicated application time. Longer stability is not guaranteed.Can be combined with all LOBA water-based finishes and sealers. The application properties of the finish, its product combinability, and the drying time remain unchanged. Refer to the Technical Data Sheet of the corresponding finish.

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA.

Technical

Safety Data Sheet | Technical Data Sheet