Loba Hybrid Oil-Modified Water-Based Wood Floor Finish – 1 Gal.

For heavy wear. In addition to the film-forming process common in water-based finishes, an oxidative curing reaction produces exceptional finish properties, above all high scratch resistance.

Features

• Solids: 35 ±2%
• Viscosity DIN 4: 27 ±2s
• Shelf life: 12 months in unopened containers. Store and transport between 40°F to 75°F (5°C to 25°C). KEEP FROM FREEZING.
• US Regulatory VOC: < 86 g/l
• Application Tool: LOBA Micro 120 Roller, T-bar, Trim pad, Lambswool, Brush, Roller
• Coverage: 500-600 square feet per gallon per coat.
• Drying Time: Earliest possible recoating after 4-6 hours. | Fully cured after 5 days. | If there is a delay in drying wait until you can see that the surface is completely dry.

Screen and Recoat

• Clean floor, abrade with LOBASAND 180 grit perforated pad (or equivalent). Vacuum floor then tack using a LOBA Mop and a new/clean LOBA microfiber mop pad lightly dampened with water to remove all dust.
• Apply finish following instructions.
• Always prepare test areas to determine compatibility, appearance, and desired results.
• Do NOT use on floors finished with UV cured, oxide containing, factory applied finishes.

Compatibility

When this product is used in combination with other LOBA products the technical information of these products must be followed. Refer to the Technical Data Sheets. LOBA cannot guarantee the suitability of products other than LOBA.

Technical

Safety Data Sheet | Technical Data Sheet