Titebond Cold Press Veneer

Features & Benefits

• Economical Alternative to Contact Cement
• Formulated To Minimize “Bleed-Through”
• Moderate Speed of Set
• No Harmful Vapors
• Safe – Nonflammable

Application Guidelines

• Application Temperature: Above 50°F (10°C)
• Open Assembly Time: 15 minutes (70°F./50% RH)
• Total Assembly Time: 15-20 minutes (70°F./50%RH)
• Minimum Required Spread: Approximately 6 mils or 250 square feet per gallon
• Required Pressure Application: 100-250 psi, depending on substrates
• Method Of Application: For most consistent coverage a mechanical spreader is recommended.
• Cleanup: Damp cloth while glue is wet. Scrape off and sand dried excess.
• Limitations: Titebond Cold Press for Veneer is specifically designed for veneering and is not suited for other types of assembly applications. Not recommended for exterior use or where moisture is likely. Do not use when temperature, glue or materials are below 50°F. Freezing may not affect the function of the product but may cause it to thicken. Agitation should restore product to original form. NOTE: STIR PRODUCT BEFORE USE TO ENSURE UNIFORMITY. KEEP FROM FREEZING.

Physical Properties

• Type: Modified PVA emulsion
• Calculated Voc: 2.0 g/L
• State: Liquid
• Weight Per Gallon: 9.2 lbs.
• Color: Tan
• Dried Film: Dark Brown
• Flashpoint: 200°F
• Solids: 42%
• Freeze / Thaw Stability: Stable
• Viscosity: 4,500 cps
• PH: 4.9
• Chalk Temperature: To assure a good bond, 50°F is the lowest recommended temperature of the glue, air and materials during application.
• Storage Life: 12 months in tightly closed containers at 70°F

Bond Strength ASTM D-905 (On Hard Maple)

• Temperature: Room; Strength: 2,500 psi; Wood Failure: 6%
• Temperature: 150°F. Overnight; Strength: 2,508 psi; Wood Failure: 0%

SDS

• 1 qt.
• 1 Gal.
• 5 Gal.
• 55 Gal.

TDS

• 1 qt.
• 1 Gal.
• 5 Gal.
• 55 Gal.