Titebond PVC Trim Adhesive & Sealant

Features & Benefits

• Superior Handling and Application – Provides A Quick, Efficient Installation
• 2 In 1 Formulation – Adheres and Seals PVC to A Variety of Substrates
• Bonds Virtually Any Material – Unique Ability to Bond Non-Porous to Non-Porous Materials
• Voc-Compliant – Exceeds All Major Green Building Specifications
• Weatherproof – Resists the Elements and Maintains Its Integrity
• Extremely Durable, Yet Flexible – Tenacious Bond Strength That Will Flex with the PVC
• Low Temperature Extrusion – Can Be Extruded Down To 0°F
• UV-Resistant – Will Not Yellow or Crack Overtime

Application Guidelines

• Application Temperature: Above 0°F (-18°C)
• Preparation:
  • Remove nozzle and cut tip of nub.
  • Puncture foil seal and screw nozzle back onto cartridge.
  • Cut tip on slant for 1/4’’ to 3/8’’ bead and place in cartridge gun.
• Application – For Adhering:
  • Surfaces must be clean and free of any material that may prevent adequate adhesion.
  • Apply the adhesive to the PVC board to be installed in either a continuous or spot bead.
  • Adhere materials within 10-20 minutes based on environmental conditions.
  • Press surfaces firmly together with a slight twisting motion.

Note: For longer runs of PVC trim and beadboard, adhering PVC to sub fascia is recommended to assist in expansion and contraction of the PVC.

• Application – For Sealing:
  • Surfaces must be clean and free of any material that may prevent adequate adhesion.
  • Force sealant into clean joint. Always apply sealant in bead form.
  • To ensure neat sealant lines, mask areas adjacent to joints. Once sealant is dry to the touch and does not transfer, remove masking tape.

Note: Ensure that initial joint width can accommodate expected substrate movement (±50% movement capability).

• Cleanup: Tools and adhesive may be cleaned with acetone or isopropyl alcohol when uncured. Follow solvent vendor’s precautions. Once cured, adhesive must be scraped from surface.
• Painting: Sealant is intended for exterior use. If used indoors, sealant may need to be painted. In most cases, painting may occur one hour after application with a high-quality acrylic, water-based (latex) paint that does not contain plasticizer. For other paint types, a compatibility test is recommended.
• Coverage: 10.1 oz. Cartridge
  • 1/8″ Bead: 123 ft.
  • 1/4″ Bead: 31 ft.
  • 3/8″ Bead: 14 ft.
  • 1/2″ Bead: 8 ft.
• Limitations: Air, adhesive and surface temperature should be above 0°F. Not recommended for continuous submersion or use below the waterline. When using on non-porous substrates, mist with water to speed curing.

Physical Properties

• Viscosity: 102,000 cps.
• Solids: 98%
• Open Time: 10-20 minutes
• Freeze / Thaw Stability: Not affected by freezing
• Shrinkage: None
• Odor: Low
• Voc: 50 g/L
• Storage Life: 36 months

Specifications & Certifications

• ASTM C920 Type S, Grade NS, Class 50, Use NT, M, G and A
• Federal Specification TT-S-00230C Type II Class A

SDS

• Safety Data Sheet

TDS

• Technical Data Sheet