Titebond Blacktop Repair Sealant

Features & Benefits

• Ideal For: Sealing Driveways, Playgrounds, Parking Lots and Pavement.
• Seals: Asphalt, Metal, Masonry, Wood, and Most Common Building Materials.
• Fills And Seals Cracks in Asphalt Surfaces
• Weather-Resistant Seal
• Durable And Flexible – Resists Oil, Gas, Grease & Salt
• Textured Formula Blends with Surface
• Extrudes Easily, Excellent Adhesion
• Mildew Resistant
• UV-Resistant

Application Guidelines

• Application Temperature: Above 40°F (4°C)
• Service Temperature Range: -25°F to 180°F (-31°C to 82°C)
• Method Of Application: Cartridge/caulking gun
• Working Time: Approximately 10-15 minutes for a 1/4″ bead
• Application Directions: 1. Surfaces must be clean and free of any material that may prevent adequate adhesion. Properly designed joint not to exceed 1/2″ in width. 2. Cut tip at 45° angle to desired bead width and place in cartridge gun. 3. Force sealant into clean joint. If necessary, smooth bead immediately. 4. Do not allow foot or vehicular traffic on repaired area until it is completely dry. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability. NOTE: Two layers of Blacktop Repair, 1/4” to 1/2” thick that are allowed to dry thoroughly between applications, are better than one heavy layer.
• Cleanup: Clean uncured material with water. After curing, excess sealant must be cut or scraped away.
• Coverage:
  • 10.1 oz. Cartridge
    • 1/8” Bead: 123 ft.
    • 1/4″ Bead: 31 ft.
    • 3/8” Bead: 14 ft.
    • 1/2″ Bead: 8 ft.
• LIMITATIONS: Not designed for continuous submersion or use below the waterline. Air, sealant, and surface temperature should be above 40°F. Do not apply if rain is expected within 12 hours. Cure time is dependent upon ambient conditions including temperature and humidity. The sealant should be dry to the touch and ready to paint in 2-4 hours. Allow to cure for 24 hours before direct contact with water. Wait 24 hours prior to coating with an asphalt or tar-based driveway sealer. For best results, store in a dry location at or below 75°F.

Physical Properties

• Type: Acrylic latex
• Calculated Voc: 50 g/L (<1.5%)
• Color: Black
• Solids: 83%
• Flashpoint: Solvent free/Not applicable
• Viscosity: 550,000 cps
• Freeze / Thaw Stability: Stable
• Storage Life: 24 months in a dry location at or below 75°F

Specifications

• Exceeds:
  • ASTM C834 TYPE OP GRADE -18°C

Warranty Statement

Liability is limited to product replacement only.

SDS

• Safety Data Sheet

TDS

• Technical Data Sheet